Outback Power Systems VFX Series Programming Manual - Manual (Page 11)

10
ADV
choose device:
FX CC DC MATE
ADV/FX/PAGE 1-----------------
choose category:
ADV INV CHGR PG2
ADV/FX/INVERTER-------P00
search 6
sensitivity
DOWN INC DEC PORT
ADV/FX/INVERTER-------P00
search 8 cycles
pulse length
DOWN INC DEC PORT
INVERTER MENU
The INVERTER screens allow adjusting the inverter’s operations to match the AC load and battery
recharging requirements, including the search functions, low-battery cut-out, the FX’s output voltage,
and resetting the FX to its factory default values.
After entering the ADVANCED screens, press
on the choose device screen.
Press .
Use the search sensitivity screen to determine the
size of an AC load needed for the FX to turn ON
and leave SEARCH mode.
• Pressing decreases sensitivity (a bigger
load is needed to turn the FX on)
• Pressing increases the sensitivity
which means a smaller load (less wattage) will
turn the FX on
• Decreasing to zero disables SEARCH mode
Press to view the search pulse length
screen.
The FX produces pulses to detect AC loads. The
search pulse length screen allows adjusting the
number of pulses (from 4 to 20) or cycles to
more reliably detect AC loads. A setting of 8 or
higher, adjusted using and ,
is recommended. Press to open the
search pulse spacing screen.
FX
INV
INC
DEC
DOWN
INC DEC
DOWN