Programming the fxs – Outback Power Systems VFX Series Programming Manual User Manual
Page 28

27
Once the MATE recognizes each FX (and Charge Controller or CC), push and hold the fi rst two soft keys
simultaneously to return to the MAIN menu. To program the FXs, go to the ADV/FX/STACK menu on
the MATE navigating with the following steps:
Press
.
NOTE:
Pressing and holding the fi rst two soft keys
at the same time will always bring up the Main
Menu screen.
Push any soft key on the ADV/SETTINGS/WARNING
screen and go to the ADV/PASSWORD screen.
MAIN--------------------------
12:12:16A
SUM STATUS SETUP ADV
ADV/SETTINGS/WARNING
changes made could adversely aff ect
system performance
PROGRAMMING THE FXs
The screen displays 132. Press until it
scrolls to the password 141.
ADV/PASSWORD----------------
enter the password
132
ENTER INC DEC EXIT
ADV/PASSWORD----------------
enter the password
141
ENTER INC DEC EXIT
Push .
ADV
INC
ENTER