Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 66)

Mid-Tech Controller PF3000 Pro
Application Rate Mode Ag Leader Technology
July 2003 2-52
Actual Rate Scale Factor: This setting is required to prevent
data loss in the log file (YLD file) when the units/sec of
application get above 3. Use the chart below for setting. The
rate actually applied and rate displayed on PF is unaffected by
this setting. When the log file is mapped in Ag Leader's SMS
mapping program, the mapped actual rate will be 1/10
th
of the
real rate if the Actual Rate Scale Factor is 0.100. If it is
0.010, the mapped actual rate will be 1/100
th
the real rate.
The mapped actual rate can be scaled back up in SMS. The
summary actual rate in SMS is unaffected by this setting.
Avg. Speed Swath Application Rate between Scale Factor
0-25 mph 0-80 ft 0-10 units/ac 1.000
0-10 mph 0-80 ft 11-100 units/ac 1.000
11-15 mph 0-50 ft 11-100 units/ac 1.000
11-15 mph 51-80 ft 11-100 units/ac 0.100
16-25 mph 0-80 ft 11-100 units/ac 0.100
0-25 mph 0-80 ft 101-500 units/ac 0.100
0-10 mph 0-80 ft 501-1000 units/ac 0.100
11-15 mph 0-50 ft 501-1000 units/ac 0.100
11-15 mph 51-80 ft 501-1000 units/ac 0.010
16-25 mph 0-80 ft 501-1000 units/ac 0.010
0-25 mph 0-80 ft 1001+ units/ac 0.010
2. Press CONTRLER SETTINGS key. Set the following:
Controller Channel: Set to channel of Mid-Tech to record
or control rate.
NOTE: This setting will not appear for Ag Logix, TASC
6000 or TASC 6100 controllers.
Controller Operating Mode: Set to liquid or granular,
whichever type the Mid-Tech console is controlling.
NOTE: This setting will not appear for TASC 6000 or TASC
6600 controllers.
3. Press EXIT key to return to screen with ADVANCED
SETTINGS key on bottom. Press the ADVANCED
SETTINGS key.
Target Rate Outside Field: This only pertains to using a
.tgt prescription file.