Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 205)

PF3000 Printing Field/Load Summary
Ag Leader Technology Harvest Mode
July 2003 4-47
Introduction You can transfer a field/load summary from your monitor to any computer
on which you have a communications and word processing program.
Computers with Microsoft Windows 3.1, Windows 95, and Windows 98
have these two types of programs. If you do not have a computer or access
to a computer, call Ag Leader Technology. We will send a memory card to
you and will print your field/load summary for you. Step-by-step
instructions are provided in the following pages for creating a field/load
summary with the accessory programs in Windows 3.1 or Windows 95 or
Windows 98.
Windows 3.1
Introduction The Terminal communications and Write word-processing programs should
be in the Accessories group in the Program Manager window. These are
very basic communications and word processing programs. You do not have
to use them if you have equivalent software that you want to use, such as
Procomm (communications) and Microsoft Word or WordPerfect (word
processing). If you use other software, you should be able to follow the
procedures given below. Simply use the commands corresponding to those
given for Terminal and Write.
Connecting the
Monitor to Your PC Follow these steps to connect the PF3000 Pro to your computer:
(Windows 3.1) Step Action
1 Remove the PF3000 Pro console from the combine, place it near
your computer, connect the provided 12 volt DC power supply.
2 With the monitor off, connect one end of the PC interface cable
(with two, nine-pin connectors) provided with the monitor to port 1
on the bottom of the monitor.
IMPORTANT: The PF3000 Pro has voltages on the nine-pin
serial port that should not be connected to your computer.
Therefore, use only the special PC interface cable (only connects
pins 2, 3, and 5) supplied by Ag Leader Technology. Do NOT use
a standard cable.