Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 24)

Card Setup PF3000 Pro
All Modes Ag Leader Technology
July 2003 2-10
Logging Hours Available/Logging Interval
1 sec 2 sec 3 sec
Ag Leader 32MB ATA
Flash Card 400 800 1200
NOTE: The logging hours available can vary from the numbers shown above
due to the number of separate files that can be stored on the card.
Log File The PF3000 Pro requires a log file to store data on a memory card. The log
file will always have a “.yld” extension and be named with the date the file
was created. Example: 98081502.yld, second file created on 08/15/98.
IMPORTANT: You must copy memory to every log file you create and
log to before you read the card into your computer. The monitor
automatically copies data to the log file every time it is shut off.
Using the Ag Leader ATA FLASH card a new log file must be created for
each day. You can not add to an old log file after a new file has been created
but you can store multiple log files on one card.
In order to log instantaneous GPS data or copy field and load data to a
memory card, a log file must be selected. Every time you turn on the monitor,
the monitor will prompt you to select or create a log file. Refer to the steps
below to select or create a log file after the monitor has been turned on.
Step Action
1 Select Log File and press the EDIT key.
2 Select a log file or press CREATE FILE key to create a new log file.
3 With the desired file selected, press the ACCEPT key.
NOTE: After you read all the log files on your card into your computer (and
make backup copies of files), it is recommended to erase the log file(s) on the
card.