Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 33)

PF3000 Pro GPS Setup
Ag Leader Technology All Modes
July 2003 2-19
Introduction The GPS 4100 or integrated GPS of the PF3000 Pro require no initial
setup to begin fieldwork. The PF3000 Pro will display a “D” or “G” on
the top right hand corner of the display to indicate a GPS signal. A “D”
indicates that you have a differential signal. A “G” indicates that you
have a GPS signal and you GPS receiver are tracking four or more
satellites. A lower case “g” indicates that you have a GPS signal but your
GPS receiver is tracking only three satellites. Your GPS receiver must
track four or more satellites to get an elevation reading. You may wish to
use the GPS to show your ground speed, which requires changing the
ground speed sensor settings. Refer to Primary and Secondary Speed
Sensor under Vehicle Setup in the PF3000 Pro Operator’s manual for
instructions.
The following provides information to change factory settings on the
integrated GPS:
Beacon Selection The settings for beacon selection are Auto range, Auto Power and
Manual.
•
Auto Range: This is the default setting. In this setting the receiver
keeps a record of the closest three beacons within the receivers range.
It then selects a beacon based on the ranking of the beacon in memory.
•
Auto Power: The receiver keeps a record of the three strongest
beacons in its range. It then selects a beacon based on the ranking of
the available beacons.
•
Manual: Allows you to input frequencies for two beacons.
To change Beacon Selection complete the following steps:
Step Action
1 Press Menu key on PF3000 Pro until SETUP is displayed
and press SETUP.
2 Press bottom left or right arrow key until GPS is
displayed and press GPS key.