Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 11)

PF3000 Pro General
Ag Leader Technology
July 2003 1-7
Area Count Switch The area count switch manually turns on and off area counting. When the
switch is in the up position area is counting. When the switch is in the
down position, area is not counting. The monitor will display either “AREA
ON” or “AREA OFF” on the bottom right corner of the display to indicate
the status of area counting.
Connectors The PF3000 Pro has seven connectors on the bottom side of the console.
The large 25-pin connector is for power and sensor connections. The four
9-pin ports (Port 1, Port 2, Port 3 and Port 4) are for connecting to a GPS
receiver, planter or fertilizer or sprayer controller or any other GPS
compatible device.
Figure 3 Rear of PF3000 Pro
Port 4 Port 3 Port 2 Port 1 25-Pin
Connector
AUX Port 1
Antenna
Connector
AUX Port 2