Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 119)

PF3000 Pro Direct Drive – Accu-Rate
Ag Leader Technology Application Rate Mode
July 2003 2-105
Actual Rate Scale Factor: This setting is required to prevent
data loss in the log file (YLD file) when the units/sec of
application get above 3. The rate actually applied and rate
displayed on PF is unaffected by this setting. Set to 1.000 if
planting. Use chart below for setting when fertilizing. When
the log file is mapped in Ag Leader's SMS mapping program,
the mapped actual rate will be 1/10
th
of the real rate if the
Actual Rate Scale factor is 1.100. If it is 0.010, the mapped
actual rate will be 1/100
th
the real rate. The mapped actual rate
can be scaled back up in SMS. The summary actual rate in
SMS is unaffected by this setting.
Avg. Speed Swath Application Rate between Scale Factor
0-25 mph 0-80 ft 0-10 units/ac 1.000
0-10 mph 0-80 ft 11-100 units/ac 1.000
11-15 mph 0-50 ft 11-100 units/ac 1.000
11-15 mph 51-80 ft 11-100 units/ac 0.100
16-25 mph 0-80 ft 11-100 units/ac 0.100
0-25 mph 0-80 ft 101-500 units/ac 0.100
0-10 mph 0-80 ft 501-1000 units/ac 0.100
11-15 mph 0-50 ft 501-1000 units/ac 0.100
11-25 mph 51-80 ft 501-1000 units/ac 0.010
16-25 mph 0-80 ft 501-1000 units/ac 0.010
0-25 mph 0-80 ft 1001+ units/ac 0.010
2. Press CONTRLER SETTINGS key. These settings appear when
Controller Make = Raws Plant. Set the following:
Drive: If you have a single drive system set to DRIVE A.
If you have a dual drive system set to DRIVE AB.
If you have a three drive system, set to DRIVE ABC.
# of seeds/row/5 rev: