Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 121)

PF3000 Pro Direct Drive – Accu-Rate
Ag Leader Technology Application Rate Mode
July 2003 2-107
These settings appear when Controller Make = Raws Fert
Fertilizer type: Set to DRY or LIQUID.
Drive: Set to Drive A.
Gate Setting (dry) or Rate Setting (liquid): If applying dry
product, enter the feed gate opening in inches. If applying
liquid and using a John Blue piston pump enter the stroke
setting (usually between 1-10).
Material density: If applying dry product, enter the density of
product in lbs/cubic feet. If applying liquid product, this
number will be automatically set to 1.0 and it can not be
changed.
Delivery Rate: If applying dry product, enter the cubic feet/rev
per 1 inch of gate setting of applicator (not hydraulic drive). If
applying liquid product and using a John Blue piston pump,
enter the gal/rev per one stroke of pump.
If pump is model LM-2450, enter 0.0047.
If pump is model LM-4450, enter 0.0076.
If pump is model LM-4950, enter 0.0152.
Jump Start Speed: Set to 2 mph.
Maximum drive RPM: Set to 500 rpm unless other wise
advised. The Pro will not let the drive rpm get above this
setting. A message "SLOW DOWN!!" will be displayed every
time the maximum rpm is reached.
Drive Switch: Set this to EXTERNAL to turn drive ON/OFF
using ON/OFF/Jump start switch or whisker switch from
Rawson. Set to INTERNAL to shut drive ON/OFF using
switch on bottom right of Pro's front panel.