Ag Leader PF3000Pro Harvest & Application Operators Manual - Manual (Page 47)

PF3000 Pro Vehicle Setup
Ag Leader Technology Harvest Mode
July 2003 2-33
Primary and
Secondary speed
sensor The monitor has four different primary speed settings. They are listed
below.
Ground Speed Sensor Primary Speed Sensor
Speed sensor on transmission WHEEL
Speed sensor on tracks TRACK
Radar gun RADAR
GPS receiver GPS
If you choose GPS as your primary speed sensor, you need to set the
secondary speed sensor to WHEEL, TRACK, or RADAR. If the GPS signal
is lost, the monitor will use the secondary speed sensor. If you do not
choose GPS as your primary speed sensor you can not set the secondary
speed sensor.
Speed sensor pulses
/ 100 ft. It is not recommended that you change this setting. This number is the
distance calibration number that is set when you perform a distance
calibration for WHEEL, TRACK or RADAR. Refer to the calibrating
distance instructions in the Calibration section. You must calibrate distance
for a WHEEL, TRACK or RADAR setting for accurate ground speed.
NOTE: If you want to use a radar gun, contact an Ag Leader Technology
dealer and purchase a special adapter cable for your radar gun.
* * *