beautypg.com

Raid controller card, 82 removing hdd from tray, 83 removing riser card assembly – HP StorageWorks 1000i Virtual Library System User Manual

Page 94

background image

Figure 82 Removing HDD from tray

Reverse the steps to install a new HDD.

RAID controller card

CAUTION:

Remove power to the server by disconnecting the power cord before removing or installing a RAID

controller card and riser assembly.

To remove the RAID controller card:

1.

On the RAID controller card, disconnect the hard drive cables that connect to the SATA

backplane, and the power cable that connects to the system board.

2.

Lift the riser card assembly out of the chassis. (The RAID controller card is connected to the

riser card assembly.)

Figure 83 Removing riser card assembly

3.

Remove the screw securing the RAID controller card to the riser card assembly and pull the

controller card from the riser card assembly PCI-X slot.

94

Component replacement