HP StorageWorks 1000i Virtual Library System - Manual (Page 43)

Figure 30 E-mail Notification settings
2. To verify that the messaging system is configured correctly, click Test.
If the test E-mail message is not successfully sent and received, correct the applicable information,
and repeat the test.
NOTE:
If the test is unsuccessful, make sure that you are using a valid SMTP Server IP Address
and that the address is working properly.
3. Click Apply.
Setting the time and date information
The VLS is originally set to its time of manufacture. Update the time and date settings to ensure that any
communication (for example, if an E-mail is automatically generated) reflects the correct date and time.
1. In the right pane, scroll down below the E-mail Notification section to locate the Set Time section.
2. Select the applicable settings, and click Apply.
Figure 31 Set time and date
After you complete these configuration steps for the management system, complete the steps outlined in
the next section, Deploying iSCSI initiators .
Deploying iSCSI initiators
iSCSI initiators are required to communicate with the iSCSI targets (VLS devices) on the VLS. Each client
that uses the VLS must be equipped with a software initiator, such as the Microsoft iSCSI Software Initiator,
or an iSCSI storage HBA (for example, the QLA4050C and QLA4052C).
If you are using Backup Exec software version 10.x or older, you will need an iSCSI card in order to
use the appliance; otherwise, a software iSCSI initiator will work.
If you are using iSCSI HBAs, install them and the associated software using the manufacturer’s instructions.
HP StorageWorks 1000i Virtual Library System 43