HP StorageWorks 1000i Virtual Library System - Manual (Page 50)

NOTE:
After the drive is created, the View/Edit Virtual Library or View/Edit Virtual Standalone
Tape screen will display. To create another device at this time, select Create Virtual Device.
Continue with Connecting devices (targets) to backup hosts (initiators) .
Connecting devices (targets) to backup hosts (initiators)
By this point you have created devices and each device knows which host uses it. Now we need to tell
each host which devices are available to it. Perform the following steps to associate devices to hosts.
NOTE:
The following process presents associating devices and backup hosts using the Microsoft iSCSI Software
Initiator. The steps and screens may be different depending on the iSCSI solution on your system.
1. On the host you want to associate with the device being created, select Start > Microsoft iSCSI
Initiator > Microsoft iSCSI Initiator.
2. On the iSCSI Initiator Properties window, click the Targets tab. As shown in Figure 39 a list of targets
associated with the host you are working on displays.
NOTE:
Initially, there are no targets to display. Targets will display as you create them.
Figure 39 Ready to find targets
3. In order to associate any new devices with this host, click Refresh. The LAN will be queried for all
devices set up for use by this host and all targets found will display ( Figure 40 ). In this manner you
can both add newly created devices and remove from the list any devices that have either been
deleted or have had their host association changed to another host.
50 Configuring the VLS1000i