HP Netserver L Server series - Manual (Page 96)

Chapter 12 Troubleshooting
88
3. Restart the system. If the system does not function, refer to "If the System
Will Not Power On." If you get an error message, follow the instructions
on the screen.
If the System Does Not Power On
Follow these steps:
1. Check to ensure that all cables and power cords are firmly plugged into
their proper receptacles.
2. Check to ensure that all parts of the system are turned on and
properly adjusted.
3. If the server is plugged into a switched multiple-outlet box, make sure the
switch on the outlet box is turned on.
4. Plug a different electrical device (such as a printer) into the power outlet,
and turn it on.
5. Unplug the power cord, wait 20 seconds, plug the power cord in again,
and restart the system.
If the System Powers On, but Fails POST (Power-On Self Test)
Do one of the following:
•
If the system gives a series of beeps, this indicates a system error. Contact
HP or your reseller.
•
If the system fails POST and an error message displays on the screen, see
the section "Error Messages." If the suggested solutions do not solve your
problem, contact HP or your reseller.
If the System Passes POST (Power-On Self Test)
but Does Not Function
If an error message displays on the screen, read the error message text for actions
to take. If the actions do not solve your problem, contact HP or your reseller.
If there is no error message, follow these steps:
1. Check to ensure that the NetServer is configured correctly in the Setup
Utility.