HP Netserver L Server series - Manual (Page 19)

Chapter 3 Removing and Replacing Covers
11
Bezel
The bezel connects to the front of the NetServer chassis with two snap-in
connectors at the top front of the chassis and three tabs that fit into three slots on
the bottom front of the chassis. To remove, pull the bezel forward until it
unsnaps, then lift the bezel forward and upward from the chassis face.
Cover 1 Cover 2 Cover 3
Pull here
Bezel Lock
Figure 3-3. Removing the HP NetServer LH 3 Bezel
CAUTION The NetServer covers are heavy. Support them as you remove
them, and allow room to move them away from the NetServer
and for storage.
Cover 1
Once you have removed the bezel, remove cover 1 by unscrewing the thumbscrew
and then pulling the cover forward to disengage it. Lift it outward and away from
the chassis.