HP Netserver L Server series - Manual (Page 30)

Chapter 5 Installing Additional Memory
22
NOTE Use only HP DIMMs listed in HP Information Assistant or in
HP Order Assistant.
System Board
DIMM Socket 0
DIMM Socket 1
DIMM Socket 2
DIMM Socket 3
Figure 5-2. DIMM Sockets
Installing Additional Memory
Installing Additional Memory in the LH 3
1. Remove the NetServer's cover 3 (see Chapter 3, "Removing and Replacing
the Covers.")
2. Install the DIMMs (see Figure 5-3):
a. Remove a DIMM from its container, handling the module by its edges.
Lay it on an anti-static surface.
b. Choose a socket into which you want to install a DIMM. DIMMs may
be installed in any combination, in any socket.
c. Spread the two retaining clips on the socket outward.
d. Align the notches on the DIMM with the keys on the socket.
e. Holding the DIMM at 90 degrees to the system board, press the DIMM
fully into the socket until the retaining clips close. If the clips do not
close, the DIMM is not inserted correctly.