HP Netserver L Server series - Manual (Page 20)

Chapter 3 Removing and Replacing Covers
12
Cover 2
Remove cover 2 by unscrewing the thumbscrew, pulling the cover forward and
then slightly sideways to disengage it. Lift it up and away from the chassis.
Cover 3
Remove cover 3 by unscrewing the thumbscrew and pulling it forward to
disengage it. Lift it outward and away from the chassis.
Replacing the HP NetServer LH 3 Covers
CAUTION Replace all covers before operating this NetServer, even for a
short time. Otherwise, damage to system components may
result due to improper cooling air flow.
Insert the tabs inside the rear of the cover into the slots at the rear of the chassis
and slide the cover toward the rear. Tighten the thumbscrew at the front of the
cover.
Removing the HP NetServer LH 3r Covers
To remove the covers, first remove the bezel from the front of the NetServer.
Bezel
The bezel has three clips that mount onto a hinge assembly, which is secured to
the NetServer chassis. To remove the bezel, simply pull it toward you until it
comes free.