HP Netserver L Server series - Manual (Page 61)

Chapter 8 Mounting the NetServer in a Rack
53
◊ Before attaching the slides, take off the removable mounting flanges
from the rear of each slide and save two hex nuts and lock washers.
◊ Next, orient the slides so the slide members extend out the front of the
rack.
◊ Start screws in one bar nut at the correct location on the front
columns. Leave the screws loose enough to accept the slide mounting
flange. Refer to Figures 8-5 and 8-6.
◊ Insert the threaded stud on the rear of the slide through the inside face
on the rear column of the rack. Fasten it in place using the lock
washer and hex nut that held the mounting flanges in place. See
Figure 8-10.
◊ Press the slide tightly against the rack columns.
◊ Tighten the screws inserted in the bar nuts to hold the front flanges of
the slides in place.