HP LaserJet M1319f Multifunction Printer - Manual (Page 70)

NOTE: The change in the setting remains active for about 2 minutes after the copy job has been
completed. During this time, Custom settings appears on the product control-panel display.
You must change the default media size in the media input tray to match the output size, or part of your
copy might be cut off.
Adjust the default copy size
NOTE: The default copy size is the size to which copies are normally reduced or enlarged. If you keep
the factory default size setting of Original=100%, all copies will be the same size as the original
document.
1. Press Setup .
2. Use the arrow buttons to select Copy setup, and then press OK .
3. Use the arrow buttons to select Def. Redu/Enlrg, and then press OK .
4. Use the arrow buttons to select the option for how you normally want to reduce or enlarge copies.
NOTE: If you select Custom: 25-400%, use the arrow keys to set the percentage of the original
size that you normally want for copies.
If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or landscape).
5. Press OK to save the selection.
The product can reduce copies to as little as 25% of the original size or enlarge copies to as much as
400% of the original size.
Reduction/enlargement settings
● Original=100%
● A4 > Ltr=94%
● Ltr > A4=97%
● Full Page=91%
● 2 pages/sheet
● 4 pages/sheet
● Custom: 25-400%
NOTE: When using the 2 pages/sheet or 4 pages/sheet setting, select the page orientation (portrait
or landscape).
Copy settings
Copy quality
Five copy-quality settings are available: Text, Draft, Mixed, Film photo, and Picture.
The factory-set default for copy quality is Text. This setting is the best for items that contain mostly text.
60 Chapter 8 Copy ENWW