Use autoreduction for incoming faxes, Set the silence-detect mode, Set the default fax reprint settings – HP LaserJet M1319f Multifunction Printer User Manual
Page 104
Use autoreduction for incoming faxes
If the fit-to-page option is turned on, the product automatically reduces long faxes up to 75% to fit the
information on the default paper size (for example, the fax is reduced from legal to letter size).
If the fit-to-page option is turned off, long faxes print at full size on multiple pages. The factory-set default
for incoming fax autoreduction is On.
If you have the stamp-received faxes option turned on, you might also want to turn on autoreduction.
This reduces the size of the incoming faxes slightly, and prevents the page-stamp from forcing a fax
onto two pages.
NOTE:
Make sure that the default media size setting matches the size of the media that is loaded in
the tray.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Fax Recv. setup, and then press
OK
.
4.
Use the arrow buttons to select Fit to page, and then press
OK
.
5.
Use the arrow buttons to select On or Off, and then press
OK
to save the selection.
Set the silence-detect mode
This setting controls whether or not you can receive faxes from older-model fax machines that do not
emit a fax signal during fax transmissions. At the time of this publication, these silent-model fax machines
represented very few of the fax machines in use. The default setting is Off. The silence-detect mode
setting should be changed only if you regularly receive faxes from someone who uses an older-model
fax machine.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Fax Recv. setup, and then press
OK
.
4.
Use the arrow buttons to select Silence Detect, and then press
OK
.
5.
Use the arrow buttons to select On or Off, and then press
OK
to save the selection.
Set the default fax reprint settings
The default fax reprint setting is On. To change this setting from the control panel, complete the following
steps:
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Fax Recv. setup, and then press
OK
.
4.
Use the arrow buttons to select Reprint faxes, and then press
OK
.
5.
Use the arrow buttons to select On or Off, and then press
OK
.
94
Chapter 10 Fax
ENWW