HP StorageWorks 1000 Modular Smart Array User Manual
Page 33
Controller Display Messages
33
05 SYSTEM NAME:
Informational
Displays the user assigned
name for the MSA1000
system. This name can be
assigned using the Array
Configuration Utility
(ACU).
06 RESTARTING
SYSTEM
Informational
Indicates that the system
has been reset and is being
restarted.
20 INITIALIZING
SCSI SUBSYSTEM
Informational
The SCSI subsystem is
being initialized as part of
the power on sequence.
21 SCANNING FOR
SCSI DEVICES
Informational
The firmware is searching
for SCSI devices attached
to the system as part of the
power on sequence.
22 INITIALIZING
SCSI DEVICES
Informational
The firmware is initializing
all SCSI devices attached to
the system as part of the
power on sequence.
23 SCSI
SUBSYSTEM
HARDWARE FAILURE
Error
The SCSI subsystem on
MSA1000 has experienced
a hardware failure and is
not operating correctly. The
array controller has halted
itself and cannot continue.
Please contact HP support.
24 BAD SCSI BUS
MODE NON-LVD
DEVICE FOUND
Error
The MSA1000 does not
support SCSI Single Ended
(SE) devices, it only
supports SCSI Low Voltage
Differential (LVD) devices.
The MSA1000 should be
powered off and then all
SCSI devices attached to it
should be examined. Any
SE devices found should be
removed and replaced with
LVD devices.
Table 3: LCD Message Descriptions
Message
Type
Description
Action