HP XP P9500 Storage - Manual (Page 234)

Table 80 SSB codes that are returned by raidcom add rcu command (continued)
raidcom add rcu
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
Failed to establish a path or the deletion operation. The following
factor can be thought. 3101 2E10 Asynchronous Get Command Status
•
Input parameter is invalid.
•
Port status or the MP Blade status is in the state of abnormal.
•
Cable is not connected correctly.
•
Port is specified incorrectly.
The operation cannot be done because the microcode is being
changed. 8004 2E11 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The specified CU number is not defined, or an LDEV is not
defined under the CU number. 7101 2E21 Asynchronous Get Command Status
The specified RCU is already registered to another product ID. 3001 2E22 Asynchronous Get Command Status
Path cannot be established because the number of RCU
registered in MCU or RCU exceeds four. 3002 2E22 Asynchronous Get Command Status
The specified SSID is already registered to another RCU. 3300 2E22 Asynchronous Get Command Status
The specified RCU is cannot be registered because there is no
free RCU. 3000 2E23 Asynchronous Get Command Status
The operation cannot be done because the number of paths
become less than the least path number. 3101 2E23 Asynchronous Get Command Status
The port attribute is not Initiator (MCU). 840A 2E30 Executing CMDRJE
Command cannot be executed because the RCU identification
code of a path is invalid. 3001 2E31 Asynchronous Get Command Status
Command cannot be executed because the serial number is not
unified in the specified path. 3101 2E31 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 00EE 2ED6 Executing CMDRJE
An internal error occurred. 3005 2ED6 Asynchronous Get Command Status
Call HP Technical Support.
The value of SSID on the remote storage system is invalid. 3300 2ED6 Executing CMDRJE
Table 81 SSB codes that are returned by raidcom delete ldev command
raidcom delete ldev
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
It exceeds the range of LDEV number. 0000 2E00 Executing CMDRJE
This command does not support the emulation type of the
specified LDEV. 000E 2E00 Asynchronous Get Command Status
The specified LDEV is used as a Business Copy pair. 0000 2E10 Asynchronous Get Command Status
234 Troubleshooting