HP XP P9500 Storage - Manual (Page 228)

Table 75 SSB codes that are returned by raidcom add thp_pool command
raidcom add thp_pool
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
LDEV number is out of range. 0000 2E00 Asynchronous Get Command Status
The value of pool ID is out of range. 6000 2E00 Executing CMDRJE
The maximum reserve ratio of V-VOL is out of range. 6002 2E00 Executing CMDRJE
The threshold of the specified High water mark is out of range. 6009 2E00 Executing CMDRJE
The operation cannot be done because the specified threshold
of Warning is larger than the threshold of the specified High
water mark. 600A 2E00 Executing CMDRJE
The specified LDEV is in the state of blocked. 0009 2E10 Asynchronous Get Command Status
The operation cannot be done because a SATA-E drive in the
state of quick formatting is in the specified LDEV. 000C 2E10 Asynchronous Get Command Status
The specified LDEV is in the state of blocked, or not installed. 0011 2E10 Executing CMDRJE
The operation cannot be performed because the pool volume
is being deleted. 600D 2E10 Asynchronous Get Command Status
The specified operation is not supported in the current microcode
version. 8002 2E10 Asynchronous Get Command Status
The pool is not in the status where the pool volume can be
added. 6003 2E11 Executing
/Asynchronous
CMDRJE
Get Command Status
The operation cannot be done because the power supply is
switched off. 8003 2E11 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The specified LDEV is not installed. 0000 2E20 Asynchronous Get Command Status
The operation cannot be performed because the memory
capacity of the shared memory (SM) is insufficient. 8103 2E21 Asynchronous Get Command Status
Thin Provisioning program product is not installed. 9007 2E21 Executing CMDRJE
Exceeded the number of pool volume that can be registered in
a pool. 0005 2E22 Asynchronous Get Command Status
The larger number of drive types than the supported
configuration cannot be added to the specified pool. 000D 2E22 Asynchronous Get Command Status
Pool volume cannot be registered because the drive type of
specified LDEV is different from the other pool volume type, or
the drive type in the pool exceeds three. 6100 2E22 Asynchronous Get Command Status
The emulation type of specified LDEV cannot be used as a pool
VOL. 0000 2E30 Asynchronous Get Command Status
The specified LDEV has the LU path definition. 0007 2E30 Asynchronous Get Command Status
The specified LDEV is used as an External Storage Access
Manager quorum disk. 000C 2E30 Asynchronous Get Command Status
The specified LDEV is used as a system disk. 000D 2E30 Asynchronous Get Command Status
The specified LDEV is already used as a pool volume. 000E 2E30 Asynchronous Get Command Status
The specified LDEV is a command device. 0010 2E30 Asynchronous Get Command Status
228 Troubleshooting