HP XP P9500 Storage - Manual (Page 225)

Table 71 SSB codes that are returned by raidcom delete pool command (continued)
raidcom delete pool
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
The operation cannot be done because the pool volume is not
of a specified pool. 0003 2E20 Asynchronous Get Command Status
Pool ID is not installed. 6000 2E20 Executing/Asynchronous CMDRJE
Get Command Status
The specified LDEV cannot be deleted because it is a top VOL
of the pool. 0052 2E30 Executing CMDRJE
The specified pool is a pool for Snapshot. 6003 2E30 Executing CMDRJE
The command cannot be accepted. After a while, execute the
same command. 00EE 2EE7 Executing CMDRJE
Pool ID is not installed. 00F9 2EE7 Executing CMDRJE
An internal error occurred. FEEC 2EE7 Executing CMDRJE
Call HP Technical Support.
The specified parameter is invalid. Check the HP P9000 RAID
Manager Reference Guide. 6002 2EF3 Executing CMDRJE
Table 72 SSB codes that are returned by raidcom add snap_pool command
raidcom add snap_pool
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
The value of LDEV number is out of range. 0000 2E00 Asynchronous Get Command Status
Pool ID is out of range. 6000 2E00 Executing CMDRJE
The maximum reserve ratio for V-VOL is out of range. 6002 2E00 Executing CMDRJE
The specified LDEV is in the state of blocked. 0009 2E10 Asynchronous Get Command Status
The specified LDEV is in the state of blocked, or not installed. 0011 2E10 Executing CMDRJE
The pool is not in the status where the pool volume can be
added. 6003 2E11 Executing
/Asynchronous
CMDRJE
Get Command Status
The operation cannot be done because the power supply is
switched off. 8003 2E11 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The specified LDEV is not installed. 0000 2E20 Asynchronous Get Command Status
The operation cannot be performed because the memory
capacity of the shared memory (SM) is insufficient. 8103 2E21 Asynchronous Get Command Status
The operation cannot be done because the SM for Snapshot is
not initialized. 8106 2E21 Asynchronous Get Command Status
Snapshot program product is not installed. 9007 2E21 Executing CMDRJE
Exceeded the number of pool volume that can be registered in
a pool. 0005 2E22 Asynchronous Get Command Status
Error messages and error codes 225