HP XP P9500 Storage - Manual (Page 195)

Table 38 Generic error codes (horctakeover and pair commands) (continued)
Value Error message Error code Category
226 Invalid return code EX_INVRCD
239 No such group EX_ENOGRP Configuration
(Unrecoverable)
247 No such device or group EX_ENOENT
246 No such device EX_ENODEV
227 No such LDEV within the RAID EX_ENLDEV
219 No such RAID unit EX_ENOUNT
220 Invalid mu# with HORC or HOMRCF EX_INVMUN
218 Unmatched Serial# vs RAID unitID EX_ENQSER
216 Extended CTgroup across RAIDs EX_EXTCTG
214 Unmatched CTGID within the group EX_ENQCTG
213 Permission denied with the LDEV EX_ENPERM
211 Permission denied with the RAID EX_ERPERM
207 Permission denied with the SLPR EX_ESPERM
221 An order to the control/command was rejected EX_CMDRJE Command I/O to RAID
(Recoverable)
237 Control command I/O error, or rejected EX_CMDIOE
248 A specified option is invalid EX_OPTINV
241 Invalid RAID command mode EX_INVMOD
240 Invalid RAID command EX_INVCMD
251 Cannot attached to HORC manager EX_ATTHOR Communication for HORCM
(Recoverable)
250 Cannot attached to a Debug layer EX_ATTDBG
255 Cannot communicate with HORC manager EX_COMERR
242 No remote host alive for remote commands, or Remote
RAID Manager might be blocked (sleeping) on an existing
I/O. EX_ENORMT Recoverable
245 Not enough core EX_ENOMEM Resource
(Unrecoverable)
Generic error codes (raidscan, raidqry, raidar, horcctl)
The following table lists the generic error codes returned by these commands:
•
raidscan
•
raidqry
•
raidar
•
horcctl
In this table, “Unrecoverable” indicates errors that cannot be recovered by reexecuting the
command, and “Recoverable” indicates errors that can be recoverable by reexecuting the command.
Error messages and error codes 195