HP XP P9500 Storage - Manual (Page 233)

Table 79 SSB codes that are returned by raidcom delete rcu command (continued)
raidcom delete rcu
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
The value of specified port is invalid. 8400 2E00 Executing CMDRJE
/Asynchronous Get Command Status
The operation cannot be done because the microcode is being
changed. 8004 2E11 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 9400 2E11 Executing CMDRJE
The serial number, the product ID, or the SSID of the target
storage system is incorrect. 3000 2E20 Asynchronous Get Command Status
The specified RCU cannot be deleted because the RCU is not
registered. 3001 2E20 Asynchronous Get Command Status
The specified CU number is not defined, or an LDEV is not
defined under the CU number. 7101 2E21 Asynchronous Get Command Status
Path cannot be deleted because there is a pair of Continuous
Access Synchronous/Continuous Access Journal, or a journal
volume is in the relevant CU. 3101 2E22 Asynchronous Get Command Status
Command cannot be executed because the RCU identification
code of a path is invalid. 3001 2E31 Asynchronous Get Command Status
The command cannot be accepted. After a while, execute the
same command. 00EE 2ED6 Executing CMDRJE
An internal error occurred. 3005 2ED6 Asynchronous Get Command Status
Call HP Technical Support.
The value of SSID on the remote storage system is invalid. 3300 2ED6 Executing CMDRJE
RCU storage system does not exist. 00D1 2EDE Executing CMDRJE
Table 80 SSB codes that are returned by raidcom add rcu command
raidcom add rcu
Description Error code Executing/
Asynchronous Error message
SSB2 SSB1
The value of CU# on the RCU exceeds the effective range. 3001 2E00 Executing CMDRJE
Invalid product ID or path registration ID. 3005 2E00 Executing CMDRJE
Command cannot be executed because the parameter of
specified RCU is invalid. 3008 2E00 Asynchronous Get Command Status
Command cannot be executed because all the CU numbers in
the RCU is not unified at the path that is specified creation or
deletion. 3009 2E00 Asynchronous Get Command Status
The value of port# on the side of RCU is invalid. 3200 2E00 Executing CMDRJE
The value of CU number is not enabled. 7100 2E00 Executing CMDRJE
/Asynchronous Get Command Status
The value of specified port is invalid. 8400 2E00 Executing CMDRJE
/Asynchronous Get Command Status
Error messages and error codes 233