HP Insight Management-Software - Manual (Page 94)

Table 43 VCEM server error messages and descriptions (continued)
Error message description
NOTE: The error message descriptions in this table use
[x] to represent variables in the error message output. Error message number
Cannot move the server profile because the specified target
Server Bay does not belong to the same VC domain group
that the server profile belongs. 2638
The target server is powered up. The operation requires
the server to be powered down. 2639
In the ethernet connection for port , the range type is not
compatible with the addresses inside the connection. 2640
In the ethernet connection for port , the connection was
replaced by a new one. To replace a connection by a new 2641
one, first edit the profile and delete the connection, then
edit the server profile again and add a new connection.
There are more than one FC SAN connections configured
as secondary SAN boot. Only one FC SAN connection
can be configured as secondary SAN boot. 2643
There is one FC SAN connection configured as secondary
SAN boot, but no one configured as primary SAN boot. 2644
There are missing or duplicate FC SAN connections. A
continuous sequence finishing on the last valid FC SAN
connection port is required. 2645
In the ethernet connection for port {0}, the selected Network
does not exist. The provided Network must exist in the VC
Domain group the Server profile belongs to. 2646
A server profile cannot have more than x Ethernet network
connections where x represents a number. 2647
Cannot perform the server profile operation because the
VC Domain {0} does not have a valid status. 2648
Cannot find FC connection for the specified interconnect
bay because the interconnect bay number is invalid. 2650
Cannot perform server profile operation because the target
server bay is not specified. Select a target server bay and
perform the operation again. 2651
Cannot move the server profile to the same target server
bay it is assigned. Select a different target server bay and
perform the operation again. 2652
The server profile is configured to use Factory Defaults for
Serial Numbers. Verify no Serial Number and no UUID 2655
are entered when using the Factory Defaults Serial
Numbers.
The port speed information could not be retrieved for the
specified connection. Verify the provided network id
corresponds to an existing network. 2657
In the FC SAN connection for interconnect bay , the base
boot configuration is not set. 2658
In the FC SAN connection for interconnect bay , the
maximum number of boot configurations was exceeded. 2659
94 Error messages