HP Insight Management-Software - Manual (Page 58)

Table 22 Parameter descriptions for -set iscsi-boot-param (continued)
Optional Required Description Parameter
x
NOTE: The
-initiatorname
parameter is required if the
-iscsibootparamdhcp
parameter is set to
disabled
.
Specifies the name used for
the iSCSI initiator on the
booting system. The initiator
name length can be a
maximum of 223 characters.
If the initiator name string
contains non-alphanumeric
characters, it should be
enclosed in quotation marks. -initiatorname
x
NOTE: The
-initiatorip parameter
is required if the
-networkparamdhcp
parameter is set to
disabled
.
Specifies the IP address that
the iSCSI initiator uses. This
value is in dotted decimal
format. -initiatorip
x
NOTE: The -mask
parameter is required if the
-networkparamdhcp
parameter
is set to disabled.
Specifies the IP network
mask that the iSCSI initiator
uses. This value is in dotted
decimal format. -mask
x Specifies the default IP route
that the iSCSI initiator uses. -gateway
This value is in dotted
decimal format.
x
NOTE: The -vlanid
parameter is required if the
-networkparamdhcp
parameter is set to
disabled
.
Specifies the VLAN number
that the iSCSI initiator uses
for all sent and received
packets. Valid values include
VLAN numbers between 1
and 4094. -vlanid
x
NOTE: The -targetname
parameter is required if the
-iscsibootparamdhcp
parameter is set to
disabled
.
Specifies the name of the
target from which to boot.
The target name length is a
maximum of 223 characters.
If the name string contains
non-alphanumeric
characters, it should be
enclosed in quotation marks. -targetname
x
NOTE: The -targetip
parameter is required if the
-scsibootparamdhcp
parameter
is set to disabled.
Specifies the primary IP
address of the iSCSI target. -targetip
x Specifies the TCP port
associated with the primary -targetport
target IP address. The default
value is 3260.
x Specifies the alternative
target IP address for use if -targetip2
the primary port is
unavailable.
58 Using VCEM commands