HP Insight Management-Software - Manual (Page 92)

Table 43 VCEM server error messages and descriptions (continued)
Error message description
NOTE: The error message descriptions in this table use
[x] to represent variables in the error message output. Error message number
The target server bay is already in use by another server
profile. 2604
The target server bay does not exist or does not belong to
the same VC domain group that the server profile belongs. 2605
In the FC SAN connection for interconnect bay , the entered
boot target WWPN is not well formed. Valid format is 2606
xx:xx:xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxxxxxx where each x represents a hexadecimal
digit.
In the FC SAN connection for interconnect bay , the
specified boot target LUN is invalid. Valid values are either 2607
a 3-digit decimal between 0 and 255, or a 13- to 16-digit
hexadecimal between 0 and FFFFFFFFFFFFFFFF.
Cannot set SAN boot settings because the specified boot
priority is not valid. 2608
Cannot create server profile because the specified server
profile does not contain the minimal required information. 2609
Verify the server profile has: - A unique name - A VC
domain group - At least two Ethernet network connection
physical ports defined - One FC SAN connection physical
port defined for each available FC SAN fabric module -
SAN boot settings for each FC SAN connection physical
port.
There are missing or duplicate Ethernet network
connections. A continuous sequence finishing on the last
valid Ethernet network connection port is required. 2610
The specified VC domain group does not exist. A server
profile must be assigned to an existent VC domain group. 2611
Cannot perform server profile assignment because the
specified VC Domain has an expired license. Apply a
permanent license and then perform the operation again. 2612
Cannot perform server profile assignment because the
target Server Bay is already in use by another server
profile. 2613
Cannot perform the Server Profile operation because there
is a server bay with a server powered up. Verify that all 2614
servers involved in the operation are powered down, and
then perform the operation again.
Cannot perform server profile assignment because the
specified target Server Bay is not valid. Verify the specified
target Server Bay belongs to a managed VC Domain. 2615
Cannot perform server profile assignment because the
server profile is already assigned to another Server Bay. 2616
The assignment was triggered explicitly, or this profile was
either (a) failed over, (b) moved, or (c) edited.
Cannot perform server profile assignment because an
exception occurred. Here is the exception: {0} 2617
Cannot perform server profile unassignment because an
exception occurred. Here is the exception: {0} 2618
92 Error messages