HP Insight Management-Software - Manual (Page 34)

set enet-connection
The -set enet-connection command modifies an Ethernet connection of a server profile.
Syntax
-set enet-connection –profilename -portnumber
[[-mcastfilter ]|
[-mcastfilterset ]]
[-network ]
[–pxe ]
[–speedtype ]
[–speed ]
Parameters
Table 11 Parameter descriptions for -set enet-connection
Optional Required Description Parameter
x Name of an existing
multicast filter associated
with the connection -mcastfilter
NOTE: The
-mcastfilter and
-mcastfilterset
parameters are optional.
You can omit them, or
specify one or the other. You
cannot specify both
-mcastfilter
and
-mcastfilterset
together.
x Name of an existing
Multicast Filter Set -mcastfilterset
associated with the
connection
x Specifies the name of the
server profile that contains
the connection to modify. -profileName
x Specifies the port number of
the connection being
modified. -portnumber
x Specifies the name of the
Ethernet network to associate -network
with the connection. Applies
to Ethernet network
connections only.
x Enables or disables PXE on
a connection. Valid values -pxe
are enabled, disabled,
and usebios.
NOTE: Only one
connection can have PXE
enabled per profile.
34 Using VCEM commands