HP Insight Management-Software - Manual (Page 57)

set iscsi-boot-param
The -set iscsi-boot-param command configures the basic iSCSI boot parameters on the
specified iSCSI connection.
Syntax
-set iscsi-boot-param
–profilename
-portnumber
-bootorder
[-lun ]
[-initiatorname ]
[-initiatorip ]
[-mask ]
[-gateway ]
[-vlanid ]
[-targetname ]
[-targetip ]
[-targetport ]
[-targetip2 ]
[-targetport2 ]
[-authentication ]
[-username ]
[-secret ]
[-mutualusername ]
[-mutualsecret ]
[-iscsibootparamdhcp ]
[-networkparamdhcp ]
[-dhcpvendorid ]
Parameters
Table 22 Parameter descriptions for -set iscsi-boot-param
Optional Required Description Parameter
x Specifies the name of the
profile associated with the
iSCSI boot parameters. -profilename
x Specifies the number of the
port for this set of
parameters. -portnumber
x Enables or disables iSCSI
boot. Selecting primary, -bootorder
secondary , or usebios
enable iSCSI boot. The
default selection for this
attribute is disabled.
x Specifies the LUN of the
target, which identifies the -lun
volume to be accessed.
Valid values for standard
LUNs are 0 to 255 decimal.
Valid values for extended
LUNs are 13- to
16-character hexadecimal
values. The default value is
zero.
set iscsi-boot-param 57