HP Insight Management-Software - Manual (Page 31)

add enet-connection
The -add enet-connection command adds a new Ethernet network connection to an existing
server profile in the VC domain.
NOTE: The maximum number of Ethernet connections that can be added to a server profile
depends on the Virtual Connect firmware version. For more information, see the HP Virtual Connect
Enterprise Manager User Guide available at:
http://www.hp.com/go/vcem/ .
Syntax
-add enet-connection –profilename
[[-mcastfilter ]|
[-mcastfilterset ]]
[-network ]
[–pxe ]
[–speedtype ]
[–speed ]
Parameters
Table 10 Parameter descriptions for -add enet-connection
Optional Required Description Parameter
x Name of an existing
multicast filter associated
with the connection -mcastfilter
NOTE: The
-mcastfilter and
-mcastfilterset
parameters are optional.
You can omit them, or
specify one or the other. You
cannot specify both
-mcastfilter
and
-mcastfilterset
together.
x Name of an existing
multicast filter set associated
with the connection -mcastfilterset
x Specifies the name of an
existing profile to which the
connection is added. -profilename
x Specifies the name of an
existing network to associate -network
with the connection. If the
network name is not
specified or is set to
unassigned
, the network
will be left unassigned and
can be assigned later.
x Enables or disables Preboot
Execution Environment (PXE) -pxe
on the network connection.
If this value is not specified,
the default will be usebios.
NOTE: Only one
connection can have PXE
enabled per profile.
add enet-connection 31