HP Insight Management-Software - Manual (Page 41)

Table 14 Parameter descriptions for -set fc-connection (continued)
Optional Required Description Parameter
x
IMPORTANT: The
-bootport parameter is
required only when the
-bootpriority
parameter
is set to either primary or
secondary
.
Specifies the target World
Wide Port Name (WWPN)
of the controller interface on
the Fibre Channel storage
target. The port name is a
64-bit identifier in the
following format:
NN:NN:NN:NN:NN:NN:NN:NN
-bootport
The designation N stands for
a hexadecimal number.
IMPORTANT: The
-bootport parameter is
required only when the
-bootpriority
parameter
is set to either primary or
secondary
.
Specifies the logical unit
number (LUN) of the volume
used for SAN boot. Valid
values include an integer
from 0 to 255 or 16
hexadecimal digits (HP-UX
only). -bootlun
Output
The function returns the result of the set operation or a jobid if –nb is specified.
Examples
•
Change the fabric of a FC SAN fabric connection:
vcemcli -set fc-connection –profilename MyProfile1 -portnumber 2
–fabric SAN_5
•
Set a FC SAN fabric connection to unassigned:
vcemcli -set fc-connection -profilename RedProfile2 -portnumber 2
–fabric ""
•
Change the FC SAN fabric of an FC SAN connection:
vcemcli -set fc-connection -profilename BlueProfile1 -portnumber 2
–fabric SAN_7
•
Change the port speed of an FC SAN connection:
vcemcli -set fc-connection -profilename BlueProfile1 -portnumber 2
–speed 4Gb
Minimum required role-based security
VCEM Group Operator
Remarks
You can obtain the job status for the jobid by executing the VCEMCLI with the –show job
command and providing the associated job ID. For more information, see
“show job” (page 74) .
set fc-connection 41