HP StorageWorks 500 G2 Modular Smart Array - Manual (Page 47)

Setup 47
1. Install the server cable management solution. Refer to the server
documentation.
2. Connect the VHDCI SCSI cables to the storage system and servers.
For Microsoft® or Linux operating systems, connect the Ethernet crossover
cable between the servers. Use the RJ-45 connectors identified as NIC 2 on
each server.
3. Connect peripheral devices, such as a keyboard, mouse, or monitor.
IMPORTANT: HP recommends the use of a KVM switchbox. Refer to
the documentation that ships with the switchbox.
Power cords
The power cord should be approved for use in your country. The power cord
must be rated for the product and for the voltage and current marked on the
electrical ratings label of the product. The voltage and current rating for the cord
should be greater than the voltage and current rating marked on the product. In
addition, the diameter of the wire must be a minimum of 1.00 mm
2 or 18 AWG,
your maximum length may be up to 3.66 m (12 ft).
WARNING: To reduce the risk of electric shock or damage
to the equipment:
• Do not disable the power cord grounding plug. The grounding
plug is an important safety feature.
• Plug the power cord into a grounded (earthed) electrical outlet
that is easily accessible at all times.
• Unplug the power cord from the power supply to disconnect
power to the equipment.
• Do not route the power cord where it can be walked on or
pinched by items placed against it. Pay particular attention to
the plug, electrical outlet, and the point where the cord extends
from the storage system.
To connect AC power cords:
1. Connect the power cords to the power supplies.
2. Connect the power cords to the AC power source.