HP XP P9500 Storage - Manual (Page 68)

Table 39 Information displayed by the FCQUERY command
Definition Displayed
content Displayed item
CCHH number of the starting address. The CCHH number specified here is
displayed if the STARTADDR parameter is specified. “00000000” is displayed
if the STARTADDR parameter is not specified. - RELATIONSHIP DETAIL
STARTING TRACK
The consistency of the extent is maintained. Y DEVICE LONG BUSY
FOR CG
The consistency of the extent is not maintained. N
Writing is not allowed. Y WRITE INHIBITED
Writing is allowed. N
CU number - LSS
Device number - CCA
Storage subsystem ID - SSID
The starting CCHH number of the copy source extent - SOURCE START
The starting CCHH number of the copy target extent - TARGET START
Copy source (S-VOL) of the relationship. Y SO
Copy target (T-VOL) of the relationship. N
The relationship is established for the entire volume. Y FV
The relationship is established in each extent unit. N
The relationship is created with COPY mode. Y CO
The relationship is created with NOCOPY mode. N
Background copy is running. Y CA
Background copy is not running. N
It is a persistent relationship. Y PR
It is not a persistent relationship. N
The updated part is managed as differential data if the S-VOL and T-VOL are
updated. Y CR
The updated part is not managed as differential data even if the S-VOL and
T-VOL are updated. N
Writing to the T-VOL is allowed. Y TW
Writing to the T-VOL is not allowed. N
The T-VOL is not a TSE-VOL. N SE
The T-VOL is a TSE-VOL. F
The relationship is not in Failed State. N FS
The relationship is in Failed State. F
The relationship is established without using the Preserve Mirror FlashCopy
function. N PM
The relationship is established by specifying "Preferred" in the Preserve Mirror
FlashCopy function. P
The relationship is established by specifying "Required" in the Preserve Mirror
FlashCopy function. R
68 Performing Compatible FlashCopy operations