HP XP P9500 Storage - Manual (Page 52)

Table 26 Parameters for the ICKDSF command (FLASHCPY ESTABLISH) (continued)
Description Value Parameter
Specifies the CU number, LDEV number, and device number
(device address) of the T-VOL on which you want to perform the
FLASHCPY ESTABLISH command. This parameter is required. CU number
LDEV number
Target device number
TARGETVOL or TGTVOL
Establishes the relationship which covers the entire volume. The
relationship will be maintained even after the background copying YES CHANOERECORDINO,
CHANOERCD, or CHRCD
process is completed, and if the S-VOL and the T-VOL are
updated, the updated part will be managed as the differential
data.
Establishes the relationship which covers the entire volume. The
relationship will be deleted after the background copying process
is completed. NO
The default setting of this parameter is NO.
If the relationship is maintained after the background copying
process is completed, the T-VOL cannot be written until the YES INHIBITTARGETWRITES, INHIBWRTS,
or NOTGTWR
relationship is deleted, or the command the prohibition of the
writing is executed.
Even when the relationship is maintained after the background
copying process is completed, the T-VOL can be written. NO
Default setting of this parameter is NO.
Establishes the relationship which covers the entire volume, and
execute the background copying process. COPY MODE
The default setting of this parameter is COPY.
Establishes the relationship which covers the entire volume. The
background copying process will not be performed. NOCOPY
The relationship is established even when the S-VOL is online. YES ONLINTGT or ONTGT
The relationship is not established when the copy target is online. NO
The default setting of this parameter is NO.
If the S-VOL or the T-VOL of the relationship established by
specifying YES for CHANOERECORDINO is updated, only the N/A RESTORE
updated part will be copied. And if you specify YES for
CHANOERECORDINO and you reverse the S-VOL or the T-VOL,
Reverse Restore will be executed and only the updated part will
be copied in this case, too.
The relationship will be maintained after the copying operation
is completed if you specify YES for CHANOERECORDINO. If
you specify NO or nothing for INCREMENTAL
CHANGERECORDING, the relationship will be withdrawn after
the copying operation is completed.
Specify the S-VOL and the T-VOL of the relationship into reverse. N/A FASTREVERSERESTORE or
FASTREVREST
•
If you specify YES for CHANOERECORDINO, only the updated
part of the S-VOL or the T-VOL of the established relationship
will be copied.
•
If you specify NO for CHANOERECORDINO or specify
nothing, only the copied part from the S-VOL to the T-VOL of
the established relationship will be copied.
• The relationship will be maintained after the copying operation
is completed if you specify YES for CHANOERECORDINO.
If you specify NO or nothing for CHANOERECORDINO, the
relationship will be withdrawn after the copying operation is
completed.
52 Performing Compatible FlashCopy operations