HP LaserJet P4015 Printer series User Manual
Page 77
Manually configure IPv4 TCP/IP parameters from the control panel
In addition to using the embedded Web server, you can also use the control-panel menus to set an IPv4
address, subnet mask, and default gateway.
1.
Press
Menu
.
2.
Press the down arrow to highlight CONFIGURE DEVICE, and then press
OK
.
3.
Press the down arrow to highlight I/O, and then press
OK
.
4.
Press the down arrow to highlight EMBEDDED JETDIRECT MENU, and then press
OK
.
5.
Press the down arrow to highlight TCP/IP, and then press
OK
.
6.
Press the down arrow to highlight IPV4 SETTINGS, and then press
OK
.
7.
Press the down arrow to highlight MANUAL SETTINGS, and then press
OK
.
8.
Press the down arrow to highlight IP ADDRESS, and then press
OK
.
-or-
Press the down arrow to highlight SUBNET MASK, and then press
OK
.
-or-
Press the down arrow to highlight DEFAULT GATEWAY, and then press
OK
.
9.
Use the numeric keypad, or press the up arrow or the down arrow to increase or decrease the
number for the first byte of the IP address, subnet mask, or default gateway.
10.
Press
OK
to move to the next set of numbers. To move to the previous set of numbers, press the
back arrow .
11.
Repeat steps 9 and 10 until the IP address, subnet mask, or default gateway is complete, and then
press
OK
to save the setting.
12.
Press
Menu
to return to the Ready state.
ENWW
Network configuration
65