HP LaserJet P4015 Printer series - Manual (Page 144)

4. Connect the network cable to the EIO card.
5. Turn on the product, and then print a configuration page to verify that the new EIO device is
recognized. See
Print the information and show-me-how pages on page 104 .
NOTE: When you print a configuration page, an HP Jetdirect configuration page that contains network
configuration and status information also prints.
Remove an HP Jetdirect print server card
1. Turn off the product.
2. Disconnect the network cable from the EIO card.
3. Loosen the two screws from the EIO card, and then remove the EIO card from the EIO slot.
4. Place the cover plate from the EIO slot onto the back of the product. Insert and tighten the two
screws.
5. Turn on the product.
132 Chapter 9 Manage and maintain the product ENWW