HP OneView for VMware vCenter User Manual
Page 56
Provisioned from Datastore to Virtual Machines
•
Current storage inventory—Number of datastores, RDMs, and unused volumes provisioned
to VMs
•
Datastore Provisioned Capacity—Total amount of storage available to the datastore
•
Datastore Used Capacity—Amount of storage used by the datastore
•
Datastore Available Capacity—Amount of available storage on the datastore
•
Datastores overprovisioned—The number of over-provisioned datastores
HP Storage Arrays
This section lists the arrays that provide storage to the selected datastore. For each array, move
the cursor over the status bar to view storage information.
The following information is displayed for each array:
•
Volumes—Number of volumes presented to the selected datastore from the array
•
Used—Amount of storage used by the datastore from the array
•
Total—Total amount of storage presented to the selected datastore from the array
•
Free pool capacity—Amount of HP storage available in storage pools
Datastores
This section lists the selected datastore. Move the cursor over the status bar to view storage
information.
The following information is displayed for the datastore:
•
Virtual disks—Number of virtual disks on the datastore
•
Total—Amount of storage on this datastore that is provisioned by VMDKs or RDMs
•
Used—Amount of storage on this datastore that is used by VMDKs or RDMs
•
% Savings—Amount of storage saved through the use of thin provisioning
Available HP StoreOnce Backup Systems
This section lists the HP StoreOnce Backup Systems available. For each HP StoreOnce Backup
System, move the cursor over the status bar to view storage information.
For each configured backup system, all the service sets are displayed. For each service set the
following information is displayed:
•
Used—The amount of data stored on the service set by the services on the service set.
•
Total—Total amount of storage on the service set.
•
Deduplication Ratio—The deduplication ratio of data stored on the service set.
Viewing detailed information
Click the Storage Volumes, Virtual Disks, HBAs, Paths, Replications, or VMs to Volumes tab to view
detailed information about the selected datastore. For information about the values displayed in
these tabs, see the following:
•
“Viewing storage volumes” (page 58)
•
“Viewing virtual disks” (page 61)
•
•
•
“Viewing replications” (page 64)
•
“Viewing VMs to volumes” (page 65)
56
Using Insight Control for vCenter