HP ProLiant DL760 G2 Server - Manual (Page 242)

Software Management
Step 2—Running ACU as a Service With Remote Accessibility
During installation (or later by running setup), choose to install ACU as a service
with remote accessibility.
The first time the ACU is run, if you have not already set up the Web agent
password, ACU will launch an applet for setting up the passwords. You must have an
administrator password set up to run ACU as a service.
To access ACU with a Web browser:
1. On either the ProLiant DL760 G2 server or a client PC, launch the preferred Web
browser.
2. Enter the address of the computer you wish to configure:
— If you are using local access, you must enter the loop-back address:
http://127.0.0.1:2301
— If you are using remote access, enter:
http://computer:2301
where computer is either the IP address or the name (under DNS) of the
system you want to manage.
After you enter the address, the Device Home Page is displayed.
NOTE: The :2301 in the URL is the port or socket number that ACU uses to
communicate with the browser. If this number is not specified, the browser might attempt
to connect to another Web page if the host server is running a Web server.
HP ProLiant DL760 Generation 2 Server User Guide 9-23
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: j-ch9 Software Management.doc
Codename: Pioneer Part Number: 201264-002 Last Saved On: 6/17/03 10:14 AM