HP Tape Library Interface Manager Software - Manual (Page 85)

Chapter 4 SAN Environments 85
Ch
apter 4
HP-UX Configuration
Use one of the Fibre Channel cards listed in Table 5 on page 20. You must
also install the fabric driver for the appropriate platform.
Configure a single path for each tape drive. The device files must be manually
selected or created, and configured properly in the software.
In
Figure 24 on page 86, ten tape drives are configured from the HP-UX host.
The following 'ioscan' shows the paths and the corresponding device files.
Note Always use the latest release of fabric drivers.
Note If MC/ServiceGuard is installed, ATS should not be configured
for SAN environments with a fabric switch.