HP Tape Library Interface Manager Software - Manual (Page 72)

72 Management Operations Chapter 3
Download a New Revision of the Firmware
Using the Web Interface
Note The firmware file and diagnostic utilities are available from HP
Support at www.hp.com/go/support . These files must be loaded
onto the local host computer before downloading firmware. First
select your product, and then select [Downloads & Drivers].
Note If firmware is downloaded to the controller card, then the entire
Interface Manager will re-boot and any backups in progress will
fail.
All Interface Manager components can be easily downloaded from the Web
interface (see Figure 17 on page 73).
1. Once the Interface Manager is configured for network access, enter the IP
address within your web browser to launch the Web-Based Library
Administrator pages. See Configuration Using the Telnet Interface on
page 38, or Configuration Using the Web Based Administrator on
page 53 for more information.
2. Select the [Configuration] tab from the main screen.
3. Select the [Firmware Download] button.
The pull down box labeled [Choose card to download] allows for
firmware to be downloaded to a single card. This may be useful if the
interface card that has just been added to the Interface Manager has old
firmware.
If a download is performed to only a single interface card, then any
backup that is being performed on any of the other interface cards will
proceed normally
4. Enter the full path name for the download file, or use the [Browse] button
to locate the file.