HP Tape Library Interface Manager Software - Manual (Page 48)

48 Management Operations Chapter 3
5. Select [5] from the Interface Card menu to inform the firmware that you
have installed a new interface card. You will be asked to supply the slot
number of the interface card to place On-Line.
6. Wait for the RDY LED to turn green. It may takes 1 to 2 minutes to reach
that point in the boot-up process.
It takes several minutes before the interface card is ready to report its
status back to the RMC. The upper right LED will turn green on the
interface card long before the interface card is ready to communicate with
the RMC.
7. To refresh the table shown under the Interface Card menu, select [Enter].
The table above the Interface Card menu will show the interface card’s
fibre connection status when the interface card is available to be
configured.
8. Once the interface card is ready to be configured, then you may need to
set its addressing mode as described in Hard Addressing on page 43, or
Soft Addressing on page 44.