HP Tape Library Interface Manager Software - Manual (Page 67)

Chapter 3 Management Operations 67
Chapter 3
Placing a Fibre Channel Interface Card On-Line Using the Web
Administrator
Note An administrator’s password is required before any changes can
be submitted.
To replace an interface card that has been removed, do the following (see
Figure 15 ):
1. BEFORE installing the interface card into the Interface Manager, attach the
SCSI cable that was removed from the old card, to the correct bus on the
new card, based on the connections printed on the cable label that is
attached to the SCSI cable.
2. Insert the new FC interface card into the slot where the old card was
removed. Gently push the card into the slot by placing pressure on the top
AND bottom of the card until it is flush with the chassis. (Pushing the card
in from the top OR bottom alone may damage the card or Interface
Manager (see Figure 7 on page 47).
3. Access the Web Administrator as described in Making Changes via the
Web Interface on page 56.
4. Select the [Operations] tab.
5. Select
the [Interface Card Replacement] button.