HP Tape Library Interface Manager Software - Manual (Page 58)

58 Management Operations Chapter 3
Setting a Time That is Different From the Time Shown
If the clock needs to be set to a time that is different from the time shown, do
the following:
1. Select [Set Interface Manager date and time manually] button.
2. Type the correct time into the fields provided.
3. Select
the [Apply] button.
None of the fibre interface cards are adversely affected by this function, so it
can be done while data is flowing through the interface cards.
The hour is given in military time, where the possible choices range from 0
through 23 hours after midnight. There is no option for handling daylight
savings time. Set your time zone as shown in Table 7 on page 41.
Changing the Ethernet Configuration Using the Web Administrator
Note An administrator’s password is required before any changes can
be submitted.
To change the Ethernet configuration using the Web Administrator, do the
following (see Figure 10 on page 59):
1. Access the Web Administrator as described in Making Changes via the
Web Interface on page 56.
2. Select the [Configuration] tab.
3. Select the [Network] button.