Plug in the fibre cable – HP Tape Library Interface Manager Software User Manual

Page 50

50 Management Operations

Chapter 3

Note

The upper right LED will turn green on the interface card long

before the interface card is ready to communicate with the RMC.

It may takes several minutes before the interface card is ready to

report its status back to the RMC.

11. Wait until the interface card boots up and reports its status to the RMC.

The upper right LED will turn green on the interface card long before the

interface card is ready to communicate with the RMC. It may takes several

minutes before the interface card is ready to report its status back to the

RMC.

12. Via Telnet, confirm that the drives are detected by the FC interface card. To

refresh the table shown under the Interface Card menu, select [Enter].

13. Via Telnet, correctly set the FC addressing mode for the new card (see

14. Plug in the fibre cable.
15. Via Telnet, check that the card has an appropriate FC connection and

address.

— To refresh the table shown under the Interface Card menu, select

[Enter]. The table above the Interface Card menu will show the interface

card’s Fibre Connection status when the interface card is available to

be configured.