HP Tape Library Interface Manager Software - Manual (Page 59)

Chapter 3 Management Operations 59
Chapter 3
Figure 10 Interface Manager Network Settings
Using DHCP
If the DHCP system is to be used:
1. Select
[Obtain network parameters automatically from a DHCP/BOOTP
server] radio button. This enables the DHCP mode.
2. Select the [Apply] button to load the configuration into the RMC.
These settings are not put into effect until the next power cycle or next RMC
reboot. None of the Fibre Channel interface cards are adversely affected by
this function, so this can be done while data is flowing through the interface
cards.