HP Tape Library Interface Manager Software - Manual (Page 64)

64 Management Operations Chapter 3
Placing a Fibre Channel Interface Card Off-Line Using the Web
Administrator
It is not necessary to remove power from the Interface Manager in order to
remove an interface card from its slot. But, it is highly recommended to inform
the firmware of your intention to do so. Placing the interface card Off-Line tells
the firmware on the RMC, on the controller card, and on the interface card that
the card is going to be removed. When it is ready for removal, the upper right
LED on the interface card will turn yellow.
Note An administrator’s password is required before any changes can
be submitted.
Note Slot number1 should contain the RMC (disregard the card type
number 2 on the card, the correct slot number is 1). Slot number
2 should contain the Controller card (disregard the card type
number 3 on the card, the correct slot number is 2). Interface
cards are in slots numbered 3 through 12.
To take a Fibre Channel interface card off-line, do the following:
1. Access the Web Administrator as described in
Making Changes via the
Web Interface on page 56.
2. Select the [Operations] tab.
3. Select the [Interface Card Replacement] button.
4. Move the mouse over the image of the interface card that you wish to
place Off-line, (see Figure 12 on page 65), and click on that image.