HP Compaq t5510 Thin Client - Manual (Page 144)

7-2
DG 410/412 Emulation
For a serial connection, click the Serial button, specify the communications port
in the Connect To box, then click Advanced for additional serial options. Refer
to the Serial Connection Settings section in chapter 2 for details.
Make the relevant selections then click OK to return to the Host Information
dialog box, then click Next .
6. The following four dialog boxes provide further configuration options which are
described in chapter 2. Click Next to advance through the dialog boxes.
Automate Login Process
Printer Port Settings
GUI Overrides
Aux Port Settings
7. When you have made your selections, click Finish to return to the Terminal
Connection Manager.
8. In the Terminal Connection Manager, display the Connections list, select the
session name you specified earlier in step 3, then click the Connect button.
Non-WBT Mode
This section describes the basic procedure for creating a session configuration when
the terminal is not in WBT mode. The options available are described in detail in the
Setup Menus chapter.
1. Display the Settings menu from the command bar and select Emulation... to
display the Emulation Settings dialog box.
2. Select the DG 410/412 terminal emulation in the Alpha Emulation list box. This
emulation provides compatibility with software designed to drive the Data
General D410/412 terminal. Click OK to close the dialog box.
3. Display the File menu from the command bar and select New Connection to
display the New Connection dialog box.
4. Select the type of host connection required in the Type list box.
For a TCP/IP connection, select TCP/IP, enter the name or internet address of
the host computer in the Connect To box, then click Configure for additional
Telnet options. Refer to the TCP/IP Connection Settings section in chapter 2 for
details.
For a modem connection, select Modem, specify the communications port in the
Connect To box, then click Configure to display configuration options. Refer to
the Modem Connection Settings section in chapter 2 for details.
For a serial connection, select Serial, specify the communications port in the
Connect To box, then click Configure for additional serial options. Refer to the
Serial Connection Settings section in chapter 2 for details.