Canon RM-Software - Manual (Page 33)

Installation
33
S
et
u
p
2
Note
• You can click [Change] to change the destination folder.
However, we recommend that you do not change the
destination.
• To check the available disk space on each drive of the
computer and the disk space required for installation, click
[Space].
• A dialog box asking you to specify the software to be
installed is displayed. If you click [All], proceed to the step 6. If
you click [Custom], the sample dialog box above is displayed.
Select which application to install, the Storage Server or the
Viewer. Click the application that you do not want to install and
select [This feature will not be available].
Note
• When installing on a PC that has multiple network interfaces,
select the network interface to use in the [Network adapter] list
and the assigned IP address in the [IP address] list.
• If you clear the [Add storage server programs to the Windows
Firewall exception list.] check box, you need to configure
Windows Firewall after the installation is complete. For details,
see “Windows Firewall Settings” (p. 34).
One of the following icon appears on your desktop when
the installation is complete.
5 Click [Next].
6 Click [Next].
Important
If you change the network interface or IP address after this
point, you will need to reinstall the software.
7 Click [Install].
8 Click [Finish].
9 Click [Yes] to restart the computer.
Important
• You must restart the computer to enable the settings that
were made during the installation.
• You must configure the operating system after installation.
For details, see “Settings After Installation” (p. 34).
• If you reinstall this software after uninstalling it, the setting
configurations before uninstallation will not be retained. If you
want to reinstall this software, we recommend that you
backup the settings as a configuration file before
uninstallation. For details on backup, see “Chapter 8
Backup”.